Whether you’re just getting started in waterjet cutting or are an experienced operator, there are a few tips and tricks that can make your life easier. These tips and tricks will give you a clear picture of the process and help you get the most out of your machine.
Tip# 1:
The first thing to do is choose a workspace suitable for your production needs. Waterjets are powerful machines, so you want to avoid being in an area that isn’t conducive to the type of work you do. The next thing you need to do is figure out how much energy is left after your cut. You can use a simple calculator to calculate how much energy your waterjet has left after you finish a cut.
Tip# 2:
You need to level the entire sheet to cut your glass with a waterjet. You can do this by using a spirit level. You might need to make additional cuts if you work with a very thin glass sheet. The goal is to create an undamaged edge, reducing the need for secondary operations.
Tip# 3:
The waterjet is capable of cutting almost anything. But it can be difficult to achieve high pressure. Some users try to DIY their high-pressure water jet system. The good news is that most waterjet problems can be fixed with a few quick tips and tricks.
Tip# 4:
A quick and effective way to improve waterjet performance is shaving off a few millimeters from the feed rate. This will decrease the stream lag and result in a smoother edge. It also reduces the amount of dust that’s produced.
Tip# 5:
Another simple trick is to rotate the slats. You can do this vertically or horizontally. The goal is to keep the slats from pinched in any pinching points. It would help if you also replaced any slats that have become worn. This will extend the life of your working table.
Tip# 6:
The best way to avoid contamination is to ensure your workspace is clean. This includes the waterjet pump. You should also make sure that the inlet water is running properly. If you need more clarification, check the post-filter water pressure gauge. If it is low, your pump isn’t putting out enough water. If you notice a drop in the pressure, it’s time to shut the pump down.
